cancel
Showing results for 
Search instead for 
Did you mean: 

Lennar woes - stuck in routing

Kevind
New Contributor

I have a ICX-7150 that’s stuck in routing mode and I need to get it into the switch code so I can upgrade it however I can’t serial connect to it and can’t locate an IP for the device. Any suggestions?

14 REPLIES 14

Squozen
Contributor III

Do a factory reset and then it will drop back to the default IP address?

Kevind
New Contributor

Tried the factory reset method, system flashes all amber lights for upwards of 20 minutes and doesn’t stop until you power cycle it and then the system led is Amber, tried it several times 

Kevind
New Contributor

Already tried that and then the system was flashing amber on all LEDs for 20 minutes doing nothing. Power cycled and then the system led is Amber, did it again and same result over and over.  

Kevind
New Contributor

Already tried that and then the system was flashing amber on all LEDs for 20 minutes doing nothing. Power cycled and then the system led is Amber, did it again and same result over and over.