CommScope RUCKUS Community Forums

kransom · 08-01-2024

* addresses are anonymized ** I have 2 issues1. ACL was working in test environment but not in production even though everything is the same2. Understanding how inbound traffic is processed on a virtual interface* int ve 150 is the public facing inte...

kransom · 05-17-2024

Hi,I am configuring ACLs for IPv6, and it is not going as expected. There must be something I am missing as the logic, in my mind, is making sense but it is not working. I have VE 10 (Vlan 10) connected to ISP (internet), VE 20 (Vlan 20), VE 30 (Vlan...

kransom · 04-18-2024

Hi,I have been trying to get multicast working on our WiFi network. Here is a synopsis of the setup.A zone director 3050 running version 9.13.3.0 build 145. Managing mainly r600 APs with a few other models sprinkled in. There is an WLAN configured wi...

kransom · 02-28-2024

Hi,I recently purchased 4 ICX 7450 switches. The make is by Brocade not Ruckus. Is it possible to use the current stable firmware with these switches. I read that it is supported, but I am getting errors trying to write to flash."The code type 64 is ...

kransom · 02-09-2024

Hello,I am looking for replacements (really spares), for a couple network switches I have. My current setup is running 2 Brocade FCX648S-HPOE stacked by DAC cables (in the rear) with a 16GbE connection. I have been browsing the the ICX lineup for a s...

kransom · 08-01-2024

Revisiting this, it should bepermit ipv6 2600:f600:3600:1::/64 anyinstead ofpermit ipv6 any 2600:f600:3600:1::/64

kransom · 05-20-2024

I believe I have provided the necessary information. It is in a pseudo-ish format but that is it really.To give more context, for what it's worth, I was trying to make our IPv6 network be default DENY and permit known good addresses, ports, and proto...

kransom · 05-20-2024

Could you provide an example of such rule?In outboundv6 I have a rule permitting traffic from VLAN 20 to any host on VLAN 10. That is applied outbound on int ve 10.

kransom · 04-18-2024

Late reply again, but thank you. To resolve this, a flash to an older version then to the newest version was needed. Another error occurred causing an infinite reboot cycle. This was due to a bad fan module. Resolved that by replacing the fan.

kransom · 04-18-2024

Sorry, just now seeing this as I go to post another forum question. I did not know these were answered so quickly. Thank you for the reply. I ended up going with an ICX7450. With the 40GB stacking and 4x10GB modules.

CommScope RUCKUS Community Forums

User Statistics

User Activity

Inbound ACL

ACL not working

Multicast on Zone Director 3050

Firmware Upgrade for Brocade ICX7450

Switch Replacement / Spare

Re: ACL not working

Re: ACL not working

Re: ACL not working

Re: Firmware Upgrade for Brocade ICX7450

Re: Switch Replacement / Spare