CommScope RUCKUS Community Forums

dtsteinb · 08-20-2024

I upgraded my internet service to 200MBPS and when I did a speed test when on the Ruckus it would not pass 80MBPS. I was told I needed to upgrade my firmware, I did this numerous times because each time something would happen and the switch would n...

dtsteinb · 08-14-2024

How did you enable the web interface and set password?

dtsteinb · 08-08-2024

I have my laptop connected to my Ruckus and when I do a speed test I can't break 100mbps and I am on a 200mbps line. If I use the modem Xfinity sent and connect to that 5G I get the 200mbps. Is this ruckus not capable of real 5G speeds or do I need...

dtsteinb · 08-18-2023

I am trying to connect via my iphone. When I try to login I get the following messageYou are not connected to Unleased Network. Go to Settings? Yes No I am putting in the correct login info and my device is connected to the Ruckus Wifi Network. ...

dtsteinb · 08-28-2024

When I do the updates, the switch reboots and the ports that have the 2 AP;s connected do not come up while the other ports usually come up (I see the link lights on the switch). The 2 ports that have the AP's connected have NO lights. This leads m...

dtsteinb · 08-28-2024

You still refuse to answer my question. I can no longer do a factory reset as there seems to be something in the pinhole for the reset button. Just close this as I am not getting the answer I need.

dtsteinb · 08-27-2024

As I have stated before, right now the speed is correct so I am very hesitant to do the upgrade with no one for support. Also, you have not answered my question that I have asked more then once. Is there a delay on the switch for the AP's? When I ...

dtsteinb · 08-23-2024

I have not done this as I need to be able to work from home, can't have the switch go down again, and have no one to call to help. I probably will not try to upgrade for at least 2-3 weeks. I am getting the correct speed, so I am extremely hesitan...

dtsteinb · 08-21-2024

Thank you for information. So the mismatch error can be ignored but what about when I try to do a reload and get the POE firmware error? I will run those commands tonight since I am not doing an upgrade. These commands are just to allow access via...

CommScope RUCKUS Community Forums

User Statistics

User Activity

Upgrading Nightmare

Re: ICX7150-C12-Switch admin username and password

Ruckus 5G

Unleashed You are not connected to a Unleshed Network

Re: Upgrading Nightmare

Re: Upgrading Nightmare

Re: Upgrading Nightmare

Re: Upgrading Nightmare

Re: Upgrading Nightmare