CommScope RUCKUS Community Forums

Sydney_N · 07-11-2022

I'm fairly new to networking so I apologize if this is fairly obvious. I googled, but I was unsuccessful/confused.We recently received new ICX7400 switches. I consoled into each one and upgraded the firmware to 08090k and applied licenses to each. We...

Sydney_N · 05-16-2023

@happytohelp thank you for clarifying!

Sydney_N · 05-15-2023

This is helpful! However, when I tried to put "interface ve 1" on VLAN 1, it just takes me to that interface. Do you know why it would do this, @kpfleming? I believe I have layer 3 code: Software Package: ICX8200_BASE_L3_SOFT_PACKAGESW_M (config)#vla...

Sydney_N · 05-15-2023

As far as the ve on the VLAN goes, the command router-interface is deprecated:https://community.ruckuswireless.com/t5/ICX-Switches/router-interface-command-doesn-t-work-ICX-7450/m-p/40091Not sure about the IP on the single interface though

Sydney_N · 07-11-2022

Thank you Ben and Darrel,Feature license, and they all match (layer 3 prem), that's no problem. But this does answer my question in a way. Good to know for sure that a license is required for each switch, regardless of stacking.

CommScope RUCKUS Community Forums

User Statistics

User Activity

Applying a licence to a switch stack

Re: router-interface command doesn't work (ICX 7450)

Re: router-interface command doesn't work (ICX 7450)

Re: ICX8200 Interface Configuration

Re: Applying a licence to a switch stack