CommScope RUCKUS Community Forums

ipworkers_ipwor · 12-14-2015

Hi. I have a vSZ-H 3.2.0.0.790, I need to register some "old" APs (7762, 7363) on this controller. As I know I can do that if I create a new Zone and set an older firmware version. That's right? If yes, how can I upload an older firmware version? (b...

ipworkers_ipwor · 12-31-2015

Monnat, if the controller is at the provider side, yes that make sense.By this way, you can upgrade you AP the the new AP firmware version and take access to the firmware version improves. In this case, the provider will change your AP zone to a 3.2 ...

ipworkers_ipwor · 12-31-2015

Hi.You must install vSZ-H (HighScale) 3.1.1 and then upgrade it to 3.2 (do not make a 3.2 fresh install), then in the "upgraded" 3.2 you can access to 3.1.1 and 3.2 AP firmwares. After the upgrade, you can create a zone using 3.1.1 firmware (zone for...

ipworkers_ipwor · 12-31-2015

Or (as Martin say) you can use this EOL AP in a 3.1 firmware zone at the zSZ-H, then we can use EOL and not EOL APs in the same controller (but different zones).

ipworkers_ipwor · 12-22-2015

No, not apear be a problem of the "v" versions, because this option apear in the vSZ 3.1.1.0.476. Some body knows why Ruckus remove this option?

ipworkers_ipwor · 12-22-2015

ok, I have vSZ 3.2.0.0.790, and there is not the Zone option "Create new form ZD backup". Then, I think that the migration are not possible.

CommScope RUCKUS Community Forums

User Statistics

User Activity

vSZ-H Firmware Zone

Re: EOL ZoneFlex and Knowledge Base Questions

Re: EOL ZoneFlex and Knowledge Base Questions

Re: EOL ZoneFlex and Knowledge Base Questions

Re: Meshed ZD1100 | Migration - vSCG Controller Version 3.1.1.0.450

Re: Meshed ZD1100 | Migration - vSCG Controller Version 3.1.1.0.450