Hi,
I have a Ruckus switch in my Lennar home, which we moved into in early May (2021). I have a Netgear S8000 Switch in one of the rooms to support the multiple wired connections I need in that room. Last week I started having speed problems whi...
Ended up being an ethernet port on the switch (1/1/8) had gone bad and failed to pass gigabit ethernet. It refused to go any higher than 100Mbps. Ruckus is replacing the switch.
I'm right back where I started. I had to change the speed back to Auto (10Mbps) because my NAS becomes unreachable if I have the higher speed set on my port. Can anyone offer some suggestions?
After a lot of digging and guessing I was able to connect to my switch via a browser (came to find out latter that the installers disabled Telnet). I made my way to the Port->Ethernet submenu where I found this table:
My port is 1/1/8. In thi...
I forgot to add, I purchased an entirely new switch for that room and replaced the S8000 with an TP-Link TL-SG108 and still got the same 90 up and down. Point is, switch, no switch, replaced cable all of it....the speed at the wall is drastically dro...
