Our company currently using Zone director 1000 with firmware version 188.8.131.52 build 8 with 25 AP Licenses build inside it and the premium support already ended a long time ago. It manages 20 Ruckus Zoneflex 7363.
The problem is the client sometimes st...
I finally safely upgrade to 184.108.40.206 build 8When connecting to Zonedirector CLI I found out the config already has bss-minrate and ofdm-only mode.
The problem is when I type exit, or end, it says "The operation doesn't execute successfully. Please try...
Thank you for the reference and the steps. It seems I can't open the document guide, but I got it from your explanation.
I just tried, the AP stand-alone mode can broadcast the SSID with VLAN on it.
In the worst-case scenario, I need...
thank you for your answer. I appreciate that.
I will try that during off days, hope it will run smoothly.
Just to be safer, do you have any reference about recovery mode if the new firmware bricked the zonedirector?
I'm in Indonesia...
We only have one zonedirector, to be safer since we only have one zonedirector. I plan to upgrade it with stand-alone , just the zonedirector connected to my laptop.
My question is the Access Points 7363 need to be connected after e...
thank you for the answer, I will clear the event log and reboot it.
So I plan to disconnect it from the current network and make it only zonedirector and my laptop, to be more save, I will do it with UPS.
Also, I have another questio...