...bsp;generates a public key pair for use when authenticating with a remote server.
Telnet – Port 23 (If SSH doesn’t work)
nc <IPAddress of the device> 23
Example: nc 192.168.1.182 2...
Issue Description:
Due to a power outage/power spike, the RUCKUS ICX-7150-C12P Switch went to a state that we call ‘boot mode’ that is not able to boot up properly. This is the reason the RUCK...
Description:
Complete the factory reset of the RUCKUS Access Points and configure them with a new Wi-Fi network or Service Set Identifier (SSID).
Environment:
Product(s): RUCKUS R510 Access P...
Issue Description:
Upgrade RUCKUS ICX-7150-C12P to a stable Unified Forwarding Image (UFI) version for Lennar Home users to avoid any issues.
Environment:
Product(s): ICX-7150-C12P
Software...
Issue Description:
This issue may happen when your RUCKUS ICX-7150-C12P Switch starts running on the Routing code (SPR). The Switch should run on the Switching code (SPS) to avoid these issues for ...
Description:
Upgrading the RUCKUS Unleashed R510 Access Points (APs) to a stable version for Lennar Home users to avoid any issues.
Environment:
Product(s): RUCKUS R510 APs
Softwar...
Description:
Usually, for Lennar RUCKUS devices troubleshooting purposes, there are some instances where we need the IP Addresses of the RUCKUS ICX-7150-C12P Switch and RUCKUS R510 Access Points to...
Issue Description:
This issue occurs when the RUCKUS ICX-7150-C12P Switch ports get into a disabled/off state and do not transmit the Power to the Access Points via its Power over Ethernet (PoE) po...
Hi All, My WLAN got disabled, and I did a factory reset of ruckus switch and 3 APs (R510). All the 3 APs have solid green power light. Two of the APs have fast (2x) blinking green light, whi...
...etwork profiles: Domain network, Private network, and Public Network, (Please refer to the FIGURE 2 for more information).
FIGURE 2 Firewall & network protection information
When you turn o...