vSCG Setup Wizard bootstrapping error.

[william_fowler_]

When I finish the vSCG Setup Wizard I get a bootstrapping error. I tried factory defaulting and starting over but get the same thing. I'm using the steps in the Getting Started Guide. Anything I should check or do differently?

[sid_sok]

That looks about right.
I will work with the support tech to see what we can do. We have deployed the downloaded image quite a few times already and so far so good.

Try downloading a new image and redeploy from a fresh image. Don't pre-set any resources. All I did was have VM deploy from OVA file I downloaded and selected all the default settings, edit the NIC and remove two and powered on the system.

[william_fowler_]

The support guys figured it out.

After the 'restart network' step, do not reload before going to Setup Wizard. The reload was causing the problem.

Thanks!

[jonathan_fourie]

Hi gents,

How long should the system take during the bootstrapping process?
It is on 10% for the past 20 minutes

Please advise.. thanks

[jonathan_fourie]

Still nothing, staying on bootstrap @ 10%
Did a factory reset, went through the steps again, without reloading system
Bootstrapping still at 10%

VMWare 5.5
vSCG...
Mem @ 4096MB
CPUs @ 4
HDD Provisioned @ 100GB - Thick Provisioned Lazy Zeroed

Any other ideas would help

Regards

[jonathan_fourie]

Deleted the VM
Imported OVA, but changed to 200GB Thin provisioning instead

Setup the vSCG without restarting

Working!!!