RUCKUS Community Forums are now in READ-ONLY mode while we migrate to a new platform.
You will still be able to read posts and knowledge articles, but will be unable to post new content until Go Live on the new platform Monday August 17.
Lennar Smart Home customers: please contact [email protected] for assistance during the week of August 9-17.
User activity in ZD always repeated "state set to mesh learning ruckus" on same access point. (please see attached)
please explain me why that log repeated for same AP?
Thank You
please explain me why that log repeated for same AP?
Thank You
Eizens is correct.
Disable mesh on the AP [you need to know why you might or might not need it for your situation first].
The AP is checking on possible mesh connections so that if the wired connection fails then it cleanly transitions.
This article gives you an idea (as to what's happening but not what mesh is):
https://support.ruckuswireless.com/answers/000003602
To disable mesh per AP from ZD
configure...access points...edit the AP...scroll down to advanced options...
From ZD interface
Disable mesh on the AP [you need to know why you might or might not need it for your situation first].
The AP is checking on possible mesh connections so that if the wired connection fails then it cleanly transitions.
This article gives you an idea (as to what's happening but not what mesh is):
https://support.ruckuswireless.com/answers/000003602
To disable mesh per AP from ZD
configure...access points...edit the AP...scroll down to advanced options...
From ZD interface
