cancel
Showing results for 
Search instead for 
Did you mean: 

ZD1100 configuration

bethschi
New Contributor II

I'm not even a newbie.  Just trying to assist a farm that had a ZD1200 blow up and I have a ZD1100 installed and able to get to the GUI and want to configure all of the AP's that are currently out there so that they have WiFi again.

I am happy to pay someone to do this task since it is a one off and I have teamviewer set up with credentials.  

If you know of anyone that can perform this miracle, please reach out to beth@cv-wireless.com or 518-409-3535.

 

Farmers would greatly appreciate having WiFi again after a month.

1 ACCEPTED SOLUTION

Sunil,

 

Thanks for input.  I gave up on Zone Director completely and unleashed all of the APs.

View solution in original post

3 REPLIES 3

Sunil_Acharya
RUCKUS Team Member

Hi bethschi,

Greetings

May i know how many AP's are on the farm connected previously to ZD1200.

Please reset the AP to factory default and then make sure AP and new ZD1100 reachable. 

Login to the AP CLI and execute command "set director ip <zd1100 ip>"

For example "set director ip 192.168.1.10" where 192.168.1.10 is ZD1100 ip address in example.

You can check the AP status by executing "get director"

AP shows as AP managed by ZD if AP is connected to the ZD.

Please check the version of ZD and also you can check on the AP CLI by using command "get version"

Please make sure you have enough license on the ZD1100.

Regards,

Sunil Acharya

 

Sunil,

 

Thanks for input.  I gave up on Zone Director completely and unleashed all of the APs.

Hi bethschi

Greetings,

Thank you for the update.

 

If you have any additional queries on unleashed. I am happy to assist you.

Regards,

Sunil Acharya