No Gui access, even after a F/D reset, still redirected

[Emanuele]

Hello,

I try to re-use a ZD1200, performed a factory reset but this is impossible to access the management page gui, there is a redirection to an internal page, I presume an old guest/user portal.

SSH CLI is fine, but I cannot find where to disable the redirection of the GUI page to a non-existing https://xyz.123 page. I was able to define a management IP, that was different of the one that was "still" after the Factory reset, but even that one is redirected.

Via CLI I could upgrade the firmware, hoping this would erase this setting somehow, but no.

Any hint what I could try? (I perfomed a FC reset 3-4 x, 20 second pressed the dip-swicht and also via a CLI command).

Thanks !

[ms264556]

Try directly entering an https URL rather than an http URL, so that the redirect isn't triggered.

So instead of e.g. http://192.168.0.2 you can try https://192.168.0.2

[Emanuele]

Hello,  I tried this but not working, http is redirected to https and this that specific address...

[syamantakomer]

Hi Emanuele,

Could you share a screenshot of exact URL and the error you are getting?

In factory default state you should be able to access controller via CLI and GUI (setup wizard page).

Are you sure factory reset is successful?

[Emanuele]

Hello,

I just made a video starting after a CLI "set-factory" command:

EDIT: removed link

Here you can see I setup a management IP access (192.168.0.2), later you can see that despite the F-reset, the "old" .72 address is still there, and the gui interface access atempt redirect to the not existing link.