Guest Wifi - restricted subnet access
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
04-26-2018 01:15 PM
ZD1100 (I know EOL). firmware 9.9.1.0 build 52
I've set up GuestWifi and activation and it works very nicely. I want to restrict users from other subnets so I configured Restricted Subnet Access, however, I can still get to anything on these subnets...ping, file shares, web portals, etc. Not sure what else I'm doing wrong?9.9.1.0 build 52
I've set up GuestWifi and activation and it works very nicely. I want to restrict users from other subnets so I configured Restricted Subnet Access, however, I can still get to anything on these subnets...ping, file shares, web portals, etc. Not sure what else I'm doing wrong?9.9.1.0 build 52
8 REPLIES 8
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
04-27-2018 06:08 AM
looks good. Hmm... it has to work. I just tested a similar config and it is working well.
Try to create a new Guest Access Service and config new ACL. But this time step by step. Block one subnet and test it. Then a next one..
Try to create a new Guest Access Service and config new ACL. But this time step by step. Block one subnet and test it. Then a next one..
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
04-27-2018 07:06 AM
Good idea...will do and let you know results. Thanks.
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
04-27-2018 07:44 AM
Well that seemed to do the trick! When I created a new Guest Access Service, it put the four 'Deny' policies in place on it's own. However, I've added the 'allow' policy at the top so that users can get to a Crestron Mercury conferencing device for AirMedia and I can't get to that IP address. Thoughts?
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
04-27-2018 08:06 AM
Disregard that last note about the Allow rule. I waited 10 minutes after setting this rule to test it, but I guess it took a little longer for it to work. I'm all set. Thanks Igor!