how to setup VLANs on R600 unleashed

[guest_stonecali]

I'm trying to setup 4 R600 Unleashed access points with multiple VLANs. The APs have been assigned static IPs on the default LAN.  I will be creating 6 different SSIDs, each with its own DHCP scope if not VLAN. The clients will receive IPs via DHCP relay.  Where in the Unleashed setup do I create the VLANs and associate them with their SSIDs?

Thanks,
BJ

[axiom_axiom]

how to create trunk port in ruckus 510?

[benjamin_catari]

Any one has an answer to this? I'm also trying to figure out how to go about this. I'm new to Ruckus AP (R510) and I don't see the option to configure the ethernet port to trunk mode. The Unleashed web interface doesn't seem to have that option. Do i need to configure that via CLI?

[michael_brado]

Not sure if you can trunk out R510 Eth ports, please spin a new thread on your question BC. 
Its not the same as our R600, non-switch AP models.

[roger_perkin_jp]

R510 will trunk when connected - I have just setup 25 of them the Cisco switchport is configured as a trunk and I assigned the VLAN to drop into for each SSID in the Priority tab