RUCKUS Unleashed enables controller-less Wi-Fi architecture for small business environments with superior performance, lower costs and simplified management.
Showing results for 
Search instead for 
Did you mean: 

Forum Posts

WPA2/WPA3-Mixed 192-bit & Transition Disable Indication

I have a WPA2/WPA3-Mixed network authenticating with EAP-TLS on a RADIUS server. Android 12 devices connect to this network using WPA2, whereas I would prefer they connect using WPA3. However, when I set up a WPA3-only network (not mixed), leaving al...

R710 IP address after network outage

Hi,Whenever my network goes down (and my Ruckus R710 AP stays up), the IP address that is assigned to the R710 will default back to which conflicts with my router. This causes the outage to persist when the network comes back up until I p...

R720 reset to defaults after power loss

Hello,My R720 device resets back to defaults and I have to either reconfigure or restore from backup. This has happened twice so far, once when I reboot my POE switch and the other time when we lost power (I have no UPS to perform graceful shutdown)T...

alep11 by New Contributor
  • 2 replies
  • 0 kudos

R710s on to Unleashed problems MD5 error

I have a batch of used R710s that I'm trying to repurpose and they are all on a really old zoneflex firmware. I seem unable to update the firmware to any other standalone, ZF, or Unleashed firmware. I can get to the GUI and the CLI just ...

IHSystems by New Contributor
  • 0 replies
  • 0 kudos

Rogue Devices from APs in own network

I get the following Same-Network Rogue alerts for a device on my own network.How can I stop these? A new Same-Network Rogue[AA:AA:AA:AA:AA:02] with SSID[OMITTED] is first detected by AP[A320 - OMITTED@BB:BB:BB:BB:BB:01]setup AP1:mac: AA:AA:AA:AA:AA:0...

marademha by New Contributor
  • 2 replies
  • 0 kudos