cancel
Showing results for 
Search instead for 
Did you mean: 

Unleashed R710 Support UAPSD (WMM Power Save)?

theprez
New Contributor II
Does the unleashed R710 support unscheduled power save UAPSD/WMM Powersave? I can't seem to find a setting for that.

Thx
7 REPLIES 7

monnat_systems
Valued Contributor II
JP

as per datasheet - http://c541678.r78.cf2.rackcdn.com/datasheets/ds-zoneflex-r710.pdf

powersave is supported and i think R710 do supports unscheduled power save UAPSD/WMM Powersave though it does not mentions about it.

Better someone from Ruckus can confirm about it..

Thx - I contacted support and they gave me some "set " commands to use but apparently those were only for the ZoneFlex. Didn't get very far when I mentioned this was for the unleashed model. The same commands didn't work in the CLI of the unleashed.

Thx

monnat_systems
Valued Contributor II
i clearly remembered working with TAC for an issue with PS on R700 years ago:

Resolved an issue with R700 APs rebooting due to target assert failure caused by a UAPSD power save issue. (ID ER-1707)

michael_brado
Esteemed Contributor II
Yes, Unleashed supports UAPSD/WMM, and by default the DTIM is 2.

You may wish to issue a CLI command from your Master AP for "Spectralink Mode" which will
adjust DTIM=2, BSS-minrate = 5.5, RTS/CTS protection mode enabled.

See KBA-5875: Unleashed Configuring DTIM on Unleashed APs.
https://support.ruckuswireless.com/answers/000005875