Ruckus Unleashed - Join second AP

[marco_eichstet1]

Hello,

i installed the Unleashed FW on two R500 APs.

I configured the first AP and everythink looks fine. Very Nice!

After that i connected my second R500 Unleashed AP with my local Network. The AP is not discovered or listed within my Unleashed GUI. AP got an IP from my DHCP. From my Master i am able to ping the other AP. If i try to connect to this IP via Browser the Unleashed Setup Wizard appears. "Auto approve" is enabled on my Unleashed Master.

Any Ideas?

Thanks.

Kind Regards
Marco

[michael_brado]

Hi Marco, 
    Please try a factory default (indented pin by Eth ports for 8 sec) and let it boot
up again.  From your initial Unleashed AP, APs page, does the second AP appear
at all (possibly in red)?  Can you click AP details and see the firmware version?
Does the new APs version match your first Unleashed AP?  
    If your LAN has Internet connectivity, APs should be auto-upgraded when they
check with the AP registrar.  Version 2.0.9.9.608 is the official GA release that you
need on both APs.  Please let us know your status.

[marco_eichstet1]

Hi Michael,

Factory Default did not solve my problem.


Firmware Version from my first initial AP: 200.0.9.9.608
From my inital Unleasehd AP i don't see a second AP.

Firmware Version from the second AP: 200.0.9.9.608


Thanks!

[marco_eichstet1]

Hi,

i reseted my Unleashed Master AP also and recreated my Unleashed Network.
No it worked without any Problems.

Thanks.

KR
Marco

[michael_brado]

Thanks for the Good News update Marco.