cancel
Showing results for 
Search instead for 
Did you mean: 

Is this the expected R650 performance in residential setting?

Rucky860
New Contributor III

I'm replacing 3x Eero 6 Pros with 2x R650s with Unleashed. 2000 SqFt home, 3 stories, 1Gbps symmetrical ATT fiber. I'm trying to figure out if the WiFi performance I'm getting on 5GHz is within expected range, or sub-par. I followed the Blackwire Unleashed guide to the letter, but enabled 802.11r/k, enabled 'optimize for performance', and set roam factor to 2.  

Using my iPhone 14 Pro, about 10 feet away, line of clear sight, Both 2.4Ghz and 5GHz SSIDs register RSSI of -41 dBm using the Apple "AirPort utility" WiFi scanner. The Speedtest app gives me consistently about 550 down, 650 up on the 5GHz band. Both APs are connected to a QNAP 2.5Gbps PoE switch (QSW-M2116P), using PoE+ (30w) port setting, and each AP is pulling steady state 9W. This switch supports LLDP. Each AP is set to use 802.3at PoE. A Speedtest run from my hard wired Mac reaches 936/938 Mbps.

I also have a Netgear MS108EUP, which supports 2.5Gbps PoE+ and PoE++. The APs still pull a consistent 9w from that switch as well. I also got a TRENDnet 2.5Gbps PoE injector, and while it doesn't have any power out readout, the RSSI and speedtest results on my iPhone were basically the same. And just for grins, I got a Ruckus AC adapter, disabled PoE on the switch, and the RSSI and speedtest again at 10ft clear line of site was about the same. 

I saw others have issues with the R650s and being properly powered. Both Reddit and a couple of posts here residential users had issues getting full power out of the R650s. One had to use a Ruckus AC adapter, and one person on Reddit had to do a factory reset on his AP for it to fully power the antenna chains. 

I'm still not 1000% convinced my 5GHz speeds and RSSI readings are full AP power levels. But given the variety of power sources and basically same results...I guess everything is OK? I know performance varies a lot environment to environment, but others have reported much stronger RSSI and much faster Speedtest results. So that's why I'm still wondering. 

I pulled a Wireshark capture from my iPhone 14 Pro that was 10ft away, clear line of sight, to the R650:

2023-02-23_18-50-45.jpg

Am I good to go, or is more investigation needed? 

11 REPLIES 11

Rucky860
New Contributor III

@8vin Any more thoughts on my setup?

Do you have the APs mounted on the ceiling or are they just placed randomly in the rooms?