05-04-2023 03:02 AM
Hi,
I did not find any setting on the unleashed master for activating igmp v3. Is there a possibility to enable multicast and igmp v3 ?
I have installed Unleashed 200.14 firmware on my R550 Master and also on the other ap´s.
Thank you in advance for your help.
05-05-2023 12:54 AM
Hello @Truman,
Below are the command line to run AP CLI commands from Master AP.
ruckus# ap-mode
You have all rights in this mode.
ruckus(ap-mode)#
You could also run remote ap cli command from Debug mode to execute the command on all connected APs.
ruckus(debug)# remote_ap_cli -A "set qos igmp_query v3 enable"
Regards,
Parik
05-05-2023 09:34 AM
Perfect, thank you.
05-07-2023 07:39 AM
After my HomeKit implementation is still not working, I checked again the igmp status and for whatever reason, it was again disabled. How could that be, that it is disabled, after I enabled it by using the cli commands, specified by you ?
I have general HomeKit problems, since I exchanged all the access points from another brand to Ruckus.
Is there any guideline, how to get Apple HomeKit working with wireless connected components ?
Thank you in advance for your answer.
05-08-2023 03:56 AM
Hello @Truman,
Looks like AP specific config is not persistent. Please run below commands from Master AP to retain the config post reboot. In addition to IGMP, I have added commands to disable directed multicast and broadcast which disables the packet conversion from broadcast/multicast to unicast.
ruckus> enable
ruckus# config
ruckus(config)# ap-group "System Default"
ruckus(config-apgrp)# qos igmp-query v2
ruckus(config-apgrp)# qos igmp-query v3
ruckus(config-apgrp)# no lan 1 qos directed-mcast
ruckus(config-apgrp)# no lan 2 qos directed-mcast
ruckus(config-apgrp)# exit
ruckus(config)# wlan <wlan_name> #Make sure to enter the right WLAN name.
ruckus(config-wlan)# no directed-threshold
ruckus(config-wlan)# no qos directed-mulicast
Regards,
Parik
05-08-2023 01:25 PM
Hello @Parik_MN,
thanks a lot again for the detailed instructions.
Everything worked so far, besides the commands:
ruckus(config-apgrp)# no lan 1 qos directed-mcast
ruckus(config-apgrp)# no lan 2 qos directed-mcast
and
ruckus(config-wlan)# no qos directed-mulicast
For this 3 commands I am getting a "The command is either unrecognized or incomplete. To view a list of commands that you can run from this context, type '?' or 'help'." message.
Regards,
Christian