Cumulate two routers

[Anonymous]

Hi, 
I have an ADSL router on one port RJ45 in AP R500, there is another rj45 port available.
Is it possible to add an additional router on RuckusAP R500 ? if it's possible, how to do ? Many thanks

[michael_brado]

With the Solo/Standalone AP firmware, you can define an Internal network, and Route it to the second LAN port.

https://support.ruckuswireless.com/software/2431-zoneflex-solo-access-point-110-0-0-0-2005-ga-softwa...

https://support.ruckuswireless.com/documents/2404-ruckus-indoor-ap-110-0-user-guide

[Anonymous]

okay, I use  Unleashed firmware (200.7.10.202.94)

[syamantakomer]

Hi Jean,

What is the use of second router in this setup? Any specific requirement?

For sure you can connect a network device behind R500 on its second eth port but second eth port acts as a bridge/switch port. Means second router you are going to connect to this port will get IP address from the same subnet (Assuming that AP is running on Unleashed code).

Please confirm your use case.

Regards,
Syamantak Omer

[Anonymous]

sometimes I use the 4g router because it has more up and down speed. But it is in the punctual way (the router is put at the edge of my window).