CommScope RUCKUS Community Forums

sureal_alamsjah · ‎05-20-2024

Hello,

I'm trying to change the beacon interval to 200 on an Unleashed network. I've entered the CLI via SSH.

I did the following:

enable

config

show wlan.

After the command show wlan I got a list of the three existing WLANs. I want to edit WLAN 3, so I typed

wlan 3

The response was: The WLAN service '3' has been created. To save the WLAN service, type end or exit.

When I now type show wlan there is no output anymore. Does this mean that when I exit SSH I loose my WLAN config?

Regards,

Sjaak

sanjay_kumar · ‎05-20-2024

Hi @sureal_alamsjah

When you enter the command wlan 3 to edit the ssid, I assume there are special character in the SSID.
Can you try entering the command as wlan "SSID Name"

For example, I have an ssid name Ruckus-Staff so I use the command as below

ruckus> en
ruckus# config
ruckus(config)# wlan "Ruckus-Staff"
The WLAN service 'Ruckus-Staff' has been loaded. To save the WLAN service, type 'end' or 'exit'.
ruckus(config-wlan)#
ruckus(config-wlan)# end
The WLAN service 'Ruckus-Staff' has been updated and saved.
Your changes have been saved.
ruckus(config)#

View solution in original post

CommScope RUCKUS Community Forums

Changing the beacon interval