Ruckus R610 roaming scenario: No M1 frames after re association, straight data no EAPOL

[dmitry_ornatsky]

Does anybody see roaming issues with R610? We see many hard roaming failures with this device.

[syamantakomer]

Also check if FT roaming is enabled on the WLAN or not (by default it will be disabled).

[dmitry_ornatsky]

I am on the client side - no access to network management. FT roaming is hot there. I will show beacon and ruckus tag if you need

[syamantakomer]

I Dmitry,

I don't think FT roaming is enabled. Check whoever has access to network management and find-out if FT roaming is enable or not.

If FT roaming is not enabled then you should see M1, M2, M3 and M4.

Regards,
Syamantak Omer

[dmitry_ornatsky]

I could not agree more. The thing is that we sometimes see them and sometimes we do not from the same Ruckus AP MAC. Because of that roaming is hard - with a disconnect. Can this be done by a management SW on purpose - to balance load or something like that?

[dmitry_ornatsky]

Roaming is for sure not FT because tag 55 is not there and this is the snapshot of the RSN tag from the beacon: