Port Channel Settings on Cisco 3750 for a Ruckus SmartZone 100 Controller

[herman_fernando]

Hi Everyone,

I have a SmartZone 100 controller setup on a Cisco 3750.  I'm only using the 4 ethernet ports on the controller.  The 10Gb modules are not being used in the setup, so basically I'm making use of 4 out of the available 6 ports on the controller.

I have setup a port -channel for the 4 ethernet ports, but the controller goes down as soon as I enable all the ports.  Shutting down 3 of the 4 ports brings the connection back up.

Any Ideas?  Here's the config on the Cisco.

interface Port-channel3 description NIC TEAM for SmartZone 100
 switchport trunk encapsulation dot1q
 switchport trunk native vlan 200
 switchport mode trunk
 spanning-tree portfast

interface GigabitEthernet2/0/15
 description NIC TEAM SMARTZONE02 #1
 switchport trunk encapsulation dot1q
 switchport trunk native vlan 200
 switchport mode trunk
 spanning-tree portfast
 channel-group 3 mode on
!
interface GigabitEthernet2/0/16
 description NIC TEAM SMARTZONE02 #2
 switchport trunk encapsulation dot1q
 switchport trunk native vlan 200
 switchport mode trunk
 shutdown
 spanning-tree portfast
 channel-group 3 mode on
!
interface GigabitEthernet2/0/17
 description NIC TEAM SMARTZONE02 #3
 switchport trunk encapsulation dot1q
 switchport trunk native vlan 200
 switchport mode trunk
 shutdown
 spanning-tree portfast
 channel-group 3 mode on
!
interface GigabitEthernet2/0/18
 description NIC TEAM SMARTZONE02 #4
 switchport trunk encapsulation dot1q
 switchport trunk native vlan 200
 switchport mode trunk
 shutdown
 spanning-tree portfast
 channel-group 3 mode on

[justin_jeremias]

@matthew_panton_63dokw1rvce6l 

I'm unable to get this to work as well. Any luck? When I asked ruckus support, they said it's a requested feature but LACP isn't supported. I wonder if they did something to remove support if the people above had success 5 years ago.

[matthew_panton_]

No, never got it to work even with support from a Ruckus SE