CommScope RUCKUS Community Forums

herman_fernando · 09-18-2015

Hi Everyone,I have a SmartZone 100 controller setup on a Cisco 3750. I'm only using the 4 ethernet ports on the controller. The 10Gb modules are not being used in the setup, so basically I'm making use of 4 out of the available 6 ports on the contr...

herman_fernando · 10-28-2015

We are using "One Port Group" on the Smartzone 100

herman_fernando · 10-27-2015

Actually no, I made a few changes and now I can use all 4 ethernet ports. I added two config lines to each port in the channel-group that made this work:"channel-protocol lacp""channel-group 4 mode active"See my updated config below:interface Port-c...

herman_fernando · 09-18-2015

Yes, it's a new install. I've already solved the issue.Thanks.

CommScope RUCKUS Community Forums

User Statistics

User Activity

Port Channel Settings on Cisco 3750 for a Ruckus SmartZone 100 Controller

Re: Port Channel Settings on Cisco 3750 for a Ruckus SmartZone 100 Controller

Re: Port Channel Settings on Cisco 3750 for a Ruckus SmartZone 100 Controller

Re: Port Channel Settings on Cisco 3750 for a Ruckus SmartZone 100 Controller