cancel
Showing results for 
Search instead for 
Did you mean: 

Am I able to get my secondary boot code to primary?

sh_ruckus_rucku
New Contributor

Hi all,

Running a Ruckus ICX7150-C12-POE and I followed the upgrade process from https://docs.commscope.com/bundle/fastiron-08090-upgradeguide/page/GUID-5DD7EE86-6988-4CA7-81D2-22EA... to upgrade to 08.0.90j on my switch.  After copying over the image to the secondary and rebooting my switch I received the error

==========================================================================
==========       WARNING: Boot-monitor version mismatch!!!      ==========
==========   Please use "show boot-monitor" command for details ==========
=========================================================================='

Which is expected because after this boot my device used the 10.1.14 boot code in the Primary Boot code area.

When I run show boot-monitor I see:

Stack unit 1:
Current Version :  10.1.14
Recommended Version:  10.1.18   (Mismatch)

And when I run show flash, I see:

Stack unit 1:
  NAND Type: Micron NAND 2GiB (x 1)
  Compressed Pri Code size = 29360128, Version:08.0.90jT211 (SPS08090j.bin)
  Compressed Sec Code size = 29360128, Version:08.0.90jT211 (SPS08090j.bin)
  Compressed Pri Boot Code size = 786944, Version:10.1.14T225 (mnz10114)
  Compressed Sec Boot Code size = 786944, Version:10.1.18T225 (mnz10118)
  Code Flash Free Space = 1155084288

So my question is - How do I get Compressed Sec Boot Code to Compressed Pri Boot Code?  The copy command doesn't work.  😞 

Did I miss something?

Trent

4 REPLIES 4

corey_costello
New Contributor III

You’ll have to set it in the bootrom. 

https://m.youtube.com/watch?v=RHriOYYD_iI

BenBeck
Moderator
Moderator

You should just be able to re-copy the SPS08090jufi.bin and reboot. The UFI contains the bootmon image. 

Ben Beck, RCNA, Principal Technical Support Engineer
support.ruckuswireless.com/contact-us

netwizz
Contributor III

The copy commands work just fine from privlege exec.  Your switch boots, so just boot the secondary image and recopy the UFI ...

Thanks all - The re-copy seems to have done it.  Not sure if I used 'reload' instead of 'boot system flash primary' after the initial upload of 08090jufi.bin and if that had an impact.  Current show flash after re-copy:

Stack unit 1:
  NAND Type: Micron NAND 2GiB (x 1)
  Compressed Pri Code size = 29360128, Version:08.0.90jT211 (SPS08090j.bin)
  Compressed Sec Code size = 29360128, Version:08.0.90jT211 (SPS08090j.bin)
  Compressed Pri Boot Code size = 786944, Version:10.1.18T225 (mnz10118)
  Compressed Sec Boot Code size = 786944, Version:10.1.18T225 (mnz10118)
  Code Flash Free Space = 1155063808

I believe it's all good.  Thanks for the help.