cancel
Showing results for 
Search instead for 
Did you mean: 

why can not using the sampe ip address ?

tryono_taufik
New Contributor II
Hi guys, when i first setup virtual smartzone 3.6.1 in the option section for control,cluster,management. I have to fill in the ip address alternately. Why can not use the same ip address ?
Thanks
10 REPLIES 10

paul_van_der_cr
Contributor
depends on how network interfaces you have, default the image has 3 interfaces, you can remove 2 interfaces before running the first time, then you only can/have to use one ipaddress

Hi Paul, thanks, i will try remove 2 interface.

Hi Paul, how if the disconnect port ? Is it the same with remove interface ?

Hi ONOS,

Remove the interfaces. While the vSZ comes online for the first time it will check the interfaces available in VM and assign to mgmt, ctrl, clstr. Disconnecting means still its available, still vSZ will assign as 3 interfaces.
Simply, after you deploy VM image, delete NIC2 and 3 and first-start. Note: VM wizard in VMware has default option to start VM, You may need to uncheck that.

HTH
Karthik

Thanks
Karthik.

Hi Karthik,

Thanks, i have been delete the interface and working right now.