CommScope RUCKUS Community Forums

jimmy_gu_5891de · ‎02-07-2021

hi, I'm trying to setup a demo vSZ on an EXSI server

at the vSZ#

I typed in SETUP, and chose vSZ essential, but came up with this error message

"vsz essentials doesnt support multiple interfaces, please configure with one interface then setup again"

I did notice there are multiple interfaces in "show interface", so I had removed 2 other connection from EXSI, leaving only 1 connected

now show interface only showing 1 control interface , but SETUP would still giving same error message : (

eizens_putnins · ‎02-08-2021

You probably had configured all 3 interfaces on the same subnet, and this can't work at all, therefore services were not coming up.

So go for vSZ-H with 1 interface and if you can, add some 4 GB RAM at least for time of installation.

When you deploy ova, uncheck option start VM after deployment. When deployed, edit RAM (to max available), HDD (300GB recommended, will work with 100GB too, but will give error message), and delete 2 NICs, and put last NIC on correct network. Than start VM and run setup.

View solution in original post

raul_perez · ‎02-08-2021

Hi, I have the same problem. I have a laptop with 8GB of RAM. What version of vSCG do you recommend? I have followed all the steps in the manual but with the latest version of the vSCG and it gives me the same interface error

jimmy_gu_5891de · ‎02-08-2021

hi , refer to eizens_putnins's reply , 13gb minimum ram, 3 interfaces need to be on different vlans , i havent got time to test it yet : )

jimmy_gu_5891de · ‎02-09-2021

@raul_perez , 🙂

https://support.ruckuswireless.com/documents/2819-virtual-smartzone-getting-started-guide-vsz-vsz-d