Using all ports on SmartZone 100 appliances

[GreensTheorem]

Hi,

How can I use all network ports on SmartZone 100 appliances?

For example, the SFP+ ports on SmartZone 124: The manual does not state in which mode the SFP+ ports operate. Are they in active-standby? Are they connected to a virtual bridge?

I would like to connect the SFP+ ports in LAG configuration to two switches in MLAG / MCT config.

Can you please advise?

[vasanth_edward]

Hi GreensTheorem,

Thank you for writing to the RUCKUS Community Forum.

Please note that the SZ100 does not support Link Aggregation (LAG). However, the SFP+ ports can be connected to a switch, utilizing Spanning Tree Protocol (STP) on the switch to block one of the 10G ports. This provides a redundancy link as a workaround.

I hope this answers your query.