SZ 3.5 Rebooting when connected to a trunk port
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
05-22-2017 03:27 AM
Hi All, we are investigating an issue we have experienced on multiple controllers whereby if they are running SZ3.5 and are connected to a switchport configured as a trunk (in our case Cisco) the controller goes into a boot loop cycle and you are unable to communicate with it. Changing the port config to access restores stability.
We have a case open with Ruckus support but just wanted to see if anyone had experienced a similar issue?
We have a case open with Ruckus support but just wanted to see if anyone had experienced a similar issue?
6 REPLIES 6
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
03-01-2018 04:53 PM
Any update?
We have similary promblem.
We have similary promblem.
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
03-02-2018 01:38 AM
Yes issue is fixed upgrade to latest version of 3.5

