This website uses cookies. By clicking Accept, you consent to the use of cookies. Click Here to learn more about how we use cookies.
Accept
Reject
RUCKUS Self Help |   ASK the Pack
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 

Ruckus vSZ stuck on halting after configuration.

Go to solution
rok_piavec
New Contributor

‎07-20-2021 12:43 AM

I installed a 6.0.0.0 vSZ on a Hyper-V, the deployment worked fine the config website starts up.

After I finish the configuration via webUi the vSZ uses "halt -f -d -n" and get stucked at this point the VM is doing nothing...

I was trying to install the vSZ via Shell got the same issue.

I have no option to save the configurations

any ideas?

0 Kudos
1 ACCEPTED SOLUTION

Go to solution
quinn_henry
New Contributor II

‎07-20-2021 04:54 AM

This is most likely happening because you haven't assigned enough resources to the VM as per the setup guide. I believe the minimum for <100 devices is 2 cores, 14GB RAM.

As long as you are at or better than those specs, the VM should configure fine and reboot once complete.

View solution in original post

3 REPLIES 3
Copyright © 2024 Khoros, LLC