Ruckus SmartZone controller - Zone AP Firmware Support Matrix

[cecil_dsilvia]

• Ruckus Smart Zone controllers can run a Zone with legacy firmware
  • Example: a 5.2.2 smart zone controller can support zones with the following firmware versions: 

SZ 3.6.2 (GD)

SZ 5.1

SZ 5.1.1

SZ 5.1.2

SZ 5.2

SZ 5.2.1

SZ 5.2.2

• We are following the N-2 rule for GD releases
• Please note, not all features may be supported when using a legacy firmware
• It is strongly recommended to use the latest AP firmware available for the current version of the smart zone 
• Use legacy zones only for access points that do not support the current version of the controller

The current Matrix is as follows: 

SZ Version	AP Zone List
SZ3.6.2 (GD)	SZ 3.5.1	SZ 3.6	SZ3.6.1	SZ 3.6.2
SZ5.2 (LT)	SZ 3.6	SZ3.6.1	SZ 3.6.2	SZ 5.1	SZ 5.1.1	SZ 5.1.2	SZ 5.2
SZ5.2.1	SZ 3.6	SZ3.6.1	SZ 3.6.2	SZ 5.1	SZ 5.1.1	SZ 5.1.2	SZ 5.2	SZ 5.2.1
SZ5.2.2 (GD)	SZ 3.6.2 (GD)	SZ 5.1	SZ 5.1.1	SZ 5.1.2	SZ 5.2	SZ 5.2.1	SZ 5.2.2
SZ6.0 (ST)	SZ 5.2	SZ 5.2.1	SZ 5.2.2	SZ 6.0
SZ6.1 (LT)	SZ 5.2	SZ 5.2.1	SZ 5.2.2	SZ 6.0	SZ 6.1
SZ6.1.1 (LT)	SZ 3.6.2 (GD) *	SZ 5.2.2 (GD)	SZ 6.0	SZ 6.1	SZ 6.1.1

Please note: 6.1.1 (LT)'s support for 3.6.2 Zone firmware is a special case. 

[vasanth_edward]

Thank you for your feedback. We always aim to provide prompt and efficient assistance. If you have any further questions or require additional assistance, please don't hesitate to let us know. We're here to help.

[DickieF]

Hi - just checking in on this again - I noticed the compatability list mentions 3.6.2 NOT 3.6.3 - can you confim this is still a supported upgrade.

Thanks

[DickieF]

Sorry - my bad / typo.  We are running 3.6.2.0.765 - not 3.6.3x.

Apologies

[vasanth_edward]

No problem @DickieF . If shared information is helpful, please click 'Accept as Solution'.