cancel
Showing results for 
Search instead for 
Did you mean: 

Problem hotspot(WISPr) in VSZ-H

ivan_gonzalez_g
New Contributor III
Hello,
When configuring hotspot mode (WISpr) in VSZ-H version 3.4.2.x, it is not possible to access the captive portal. 
Do not load any portal or service. This was done locally and externally with an AAA server, and in neither way has it worked. Thanks for the help
7 REPLIES 7

dmitry_ivanko
New Contributor III
There are two possibilities
  • smart client is disabled. A client must force an HTTP request manually for example by a browser to get a redirect.
What's happen when you try open for example http://i.ua?
If you are redirected - you need to enable the smart client. You can start to read about this http://blog.erratasec.com/2010/09/apples-secret-wispr-request.html#.Wp6KAZPFJi8

ivan_gonzalez_g
New Contributor III
hello Dmitry Ivanko,

The solution in my case was:
1. Install the vSZ-H controller in its version for three interfaces: Control, administration and cluster.
2. Configure an ip from the public domain (xxx.xxx.xxx.xxx) to which the APs are set. set scg ip xxx.xxx.xxx.xxx.
3. Change firewall policies where ports 8099, 8090 are open.

Regards

Hi Dimitri, can you give some more information how you set it up. it's still a bit unclear to me. I have the same problem and I can't figure it out how to fix it..

Thanks in advance