Creating HA for Virtual SmartZone-H

[tien_phan_anotw]

Hi,

I am back 🙂 
I have just deployed two vSZ version 5.1.1.* on two Proxmox servers. And now wanted to make an High Availability between them. 

However, I could not find any document, also article about this one. Does anybody already do it? could you give me any advices? 

Thank you so much!

[tien_phan_anotw]

nice to see you back 🙂 why better to have 1 NIC only? can you give me more information? 
Thank you

[Anusha_Vemula]

Tien, 
 
You can setup HA with the controllers running with either 1 NIC or 3 NIC but both the controller should have the same NIC configuration.

Choosing 1 NIC or 3 NIC depends on your requirements. If you want to separate the control, cluster, and management traffic, you can set up the controllers with 3 NIC otherwise go with 1 NIC which allows all the traffic.

Note: If you select 3 NICs, you must configure each of the three interfaces to be on
three different subnets

- Anusha

[tien_phan_anotw]

I got it. Thanks a lot, Anusha. Ruckus's employee always gives the best result to me. Nice!