802.1X Virtual Smart Zone using NPS with Error Code:66

[stephen_johanns]

We have our 802.1x RADIUS Server configured to use an NPS Server.

When we test the RADIUS Server from the Smart Zone Controller or via an 802.11x enabled SSID it fails.

In the logs on the NPS Server we see

Error Code: 66 
Reason Code: The user attempted to use an authentication method that is not enabled on the matching network policy

[syamantakomer]

Hi Stephen,

Could you also attach the screenshots from the NPS policy settings.

Seems auth methods are not correctly configured in the NPS policy.

Also refer below article which explains NPS configuration settings for 802.1X authentication.

https://support.ruckuswireless.com/articles/000002109

Note: Document talks about ZoneDirector but NPS side configurations are mostly same.

Regards,
Syamantak Omer

[stephen_johanns]

Unable to access that document you shared. 

[syamantakomer]

Hi Stephen,

I have checked and I am able to open above link.

It is a premium content, so you may not be able to see it, if you don't have premium support purchased.

Regards,
Syamantak Omer

[stephen_johanns]

Thanks for the reply. I have followed the setup gudie for NPS 802.1x for VLAN assignment.

NPS Settings are:










*Same error seen whichever way we ave the EAP Types





*here we wish to return the VLAN 40 tag to SmartZone