cancel
Showing results for 
Search instead for 
Did you mean: 

ruckus icx 7150-c12p setup guide lennar home

zsl666
New Contributor

Hi, 

So my house have one switch plus 2 APs. I successfully set up the first AP and all works fine now. I am not sure how to set up my other AP. I connect the other one to the Switch. And in my wifi list, I can see the one I already set up, and the one I haven't is still naming Configure me-XXXXXX. I connected to it, and go to the unleashed.ruckuswireless.com It's a little bit different. It goes to the page that I already set up and I didn't see anywhere I can set up another addition AP. I tried to disconnect that one and reconnect it again. and now I am not able to connect to that Configure me -XXXXXX anymore. On that AP, power and Ctr light are green and 2.4g and 5g light are yellow. Should I do a AP factory reset? if yes, how can I set up the 2nd AP? do you have any tutorial?

 

Thank you

5 REPLIES 5

pinky_ruckus
Moderator
Moderator

Hi  @zsl666 ,

Greetings! 

I trust this message finds you well.

I kindly request an update on the status of the issue so that we may proceed further with resolving it. 

If we do not receive a response from you within 24 hours from the timestamp of this message, your case will proceed to closure.

Thank you.

 

Best regards,
Pinky Rajendran

RUCKUS Lennar Home Community