Some of the devices are not connecting after power outage

[pjavvaji]

Some of the devices are not connecting after the upgrade. I followed the instructions mentioned below article and switched SPR to SPS but the issue still exists.

https://community.ruckuswireless.com/t5/RUCKUS-Support-for-Lennar-Homes/Connectivity-issues-still-oc...

Compressed Pri Code size = 28660224, Version:08.0.90dT211 (SPS08090d.bin)
Compressed Sec Code size = 28660224, Version:08.0.90dT211 (SPS08090d.bin)
Compressed Pri Boot Code size = 786944, Version:10.1.15T225 (mnz10115)
Compressed Sec Boot Code size = 786944, Version:10.1.15T225 (mnz10115)

[pjavvaji]

@Imran_ruckus - I reset as per instructions and there is no luck.

Thanks

Praveen

[Imran_ruckus]

Hi @pjavvaji 

Thank you for the response and the update.

We suggest upgrading your RUCKUS ICX-7150-C12P Switch to the stable 08095g version. Please refer to the below 'Lennar Knowledge Base' guide for the same.

https://community.ruckuswireless.com/t5/RUCKUS-Lennar-Support-Knowledge/How-to-upgrade-RUCKUS-ICX-71...

Please follow the upgrade process and let me know if you are stuck at any point during the process or let me know if you have any queries in this regard,

Thank you again for your patience and understanding.

Best regards,

Imran Sanadi

RUCKUS Lennar Home Community.

[pjavvaji]

@Imarn_ruckus

I am encountering while uploading from UI and Switch .. Can you please check and help.

[pjavvaji]

I tried from switch as well .. please check error from switch

[Imran_ruckus]

HI @pjavvaji 

Thank you for the update.

Please use 8095g.bin NOT 8090k file as explained in the guide.

Also, Please enter the below commands once you log in to CLI and share the output.

Note: Hit Enter to accept each command 

enable 

show version

Thank you again for your patience and understanding.

Best regards,

Imran Sanadi

RUCKUS Lennar Home Community.