cancel
Showing results for 
Search instead for 
Did you mean: 

Seeing packet loss (8%) with Ruckus AP

acgarcia81
New Contributor

Hi, I have a Lennar home and when connected to Ruckus AP I'm seeing a 8% packet loss, sometimes even more.  I do not see this when connected to my ISP wireless AP.

Ping statistics for 192.168.254.254:
Packets: Sent = 679, Received = 619, Lost = 60 (8% loss),
Approximate round trip times in milli-seconds:
Minimum = 1ms, Maximum = 2005ms, Average = 17ms

1 REPLY 1

Jayavidhya
Moderator
Moderator

Hi @acgarcia81 

 

Greetings of the day,

 

Thanks for the details provided,

 

Based on your description, , it looks like your Switch (ICX7150 Switch) may be booting from the secondary partition ( Note: Secondary partition contains the routing code)  which is causing the bad connectivity issues. This could happen after multiple power outages, please follow up the next guide.

 

 How to Fix Routing code issues on Lennar Home users via CLI

 

Guide#1 for CLI: 

https://community.ruckuswireless.com/t5/RUCKUS-Support-for-Lennar-Homes/How-to-Fix-Routing-code-issu...

 

Guide#2 for CLI: 

https://community.ruckuswireless.com/t5/RUCKUS-Support-for-Lennar-Homes/How-to-solve-the-routing-cod...

 

 

How to Fix Routing code issues on Lennar Home users via Web GUI.

https://community.ruckuswireless.com/t5/RUCKUS-Support-for-Lennar-Homes/How-to-Fix-Routing-code-issu...

 

Note:  if you have access to the Unleashed Dashboard and the Switch can be seen from there, it may look like the following image, ICX7150-C12-Router instead of ICX7150-C12-Switch, now before starting the steps of the guide, I will advise you to cable the computer directly to the Switch, since you will have a better connectivity than if you connect via wireless. 

 

After fixing the issue of the Switch booting from the wrong partition, please perform an upgrade to the code 08095g UFI and upgrade both partitions primary and secondary with the switching code file named SPS08095gufi.bin, take into consideration that is the Switch is running a code lower than 08080 you need to upgrade twice, from the code you are to 08080f and then the recommended code 08095g UFI.

 

How to Upgrade a Switch ICX-7150-C12P using a USB flash drive

https://community.ruckuswireless.com/t5/RUCKUS-Support-for-Lennar-Homes/How-to-Upgrade-a-Switch-ICX-...

 

How to upgrade a Switch ICX7150-C12P via TFTP

https://community.ruckuswireless.com/t5/RUCKUS-Support-for-Lennar-Homes/How-to-Upgrade-a-Switch-ICX-...

 

Upgrade a switch via Web GUI (ICX7150 Switch)

https://community.ruckuswireless.com/t5/RUCKUS-Support-for-Lennar-Homes/How-to-perform-an-Upgrade-vi...

 

Please let us know if you have any queries in this regard.

 

 

Best regards,

Jayavidhya

Lennar Home Community