Second AP Disconnects the Network

[Arkham102]

I have three 510 WAPs that all lost power.  I followed the steps to reset the AP and successfully reset one 510 and it is not the Master.  From what I read, once that one is setup and working the other two should auto connect when plugged into the switch.  Anytime I plug in a second 510 the network disappears and I have to power cycle the switch to reboot it.  I cannot figure out how to add my other two WAPs to my network.  

[Arkham102]

Here is the error the switch gives when I connect more than one WAP:

PoE: Power enabled on port 1/1/5.
PoE Fatal: Vmain (48V) fault has forced all ports on slot 0 to lose power.
PoE: Power disabled on port 1/1/3 because of PSU voltage drop.
PoE: Power disabled on port 1/1/5 because of PSU voltage drop.
PoE Fatal: Vmain (48V) fault has forced all ports on slot 0 to lose power.

[Imran_ruckus]

Hi @Arkham102 

Greetings!!!

Thank you for the response and the update.

Please enter the below commands once you log in to CLI and share the output.

Note: Hit Enter to accept each command 

enable 

show version

show flash

Please let me know if you have any queries in this regard.

Thank you again for your patience and understanding.

Best regards,

Imran Sanadi

RUCKUS Lennar Home Community.

[Arkham102]

I was able to follow earlier posted instructions and updated the switch to the correct software.  A royal pain in the butt but I think that I have finally gotten it fixed.  thanks.

[Imran_ruckus]

Hi @Arkham102 

Thank you for the response.

Great!!! Good to know that the issue is now resolved. 

We appreciate your time and patience on this case.

Thank you again for contacting RUCKUS Lennar Home Community and feel free to contact us for future queries.

Have a great day ahead!!!

Best regards,

Imran Sanadi

RUCKUS Lennar Home Community.

[Arkham102]

When I plug the other two back in it shuts off the Master and it again has no power and the network disappears.