Ruckus R510 Slowness

[Anonymous]

Ruckus R510 Slowness - My topology Comcast Xfinity X1 router with 1Gbps service, measuring 850Mbps as the output. This goes to a Rucker switch C12P, and the output there is 825Mbps. However, coming out of the 2 APs, even with AP to AP speedtest, its only 400Mbps. At remote location in my house, i am only getting 40Mbps. Troubleshooting with Lennar Home network specialist, everything pointed back to the 2 APs, Ruckus R510 Unleashed. What was the last known working FW version that supported full-duplex speedtest with results near max speed ~800Mbps+?

[Anonymous]

I am not sure about being on 5Ghz all the time.  The Home network guy told me, it automatically scaled betwteen 2.4Ghz and 5Ghz as neeeded.  But, lots of smart devices in the smart home are on 2.4Gghz, so I can't completely disabled that antenna.

[Anonymous]

You can spin up a new SSID and select 5ghz instead of 'both' 2.4 and 5ghz

[Anonymous]

Just realized I left this thread after solving my problem.  To recap, got rid of Comcast.  They can't deliver 1Gbps, only spoke about it.  Went with AT&T Fiber Optics got 1Gbps all the time.  Also upgraded to R610s, so much happier.  Getting 500Mbps on WiFi all around the house.  

[Anonymous]

Rad! 500Mbps is awesome!

[Anonymous]

I agree Phy rate and Link rate aren't the same. I do wonder about joseph's speed variability. I feel like IPERF3 will give him a better more nuanced result. don't forget to run your tests in '-R' mode!