All access points including Ring door bell is not working/ no lights on.
This issue happening after power outage - need help.
Followed below link instruction - but when trying to telnet through PUTTY using serial number - cannot find COM number from Device Manager. PC shows only (Network adapter - realtek USBGbE Family Controller). Ethernet connection got established through Realtek USB GbE Family Controller - not Intel R Active Management technology. Need help.
Thank you for contacting RUCKUS Lennar Home Community.
Hope you are doing well!!!
Thank you for the detailed information you shared.
As per the case description, I could understand that your ICX-7150-C12P Switch is stuck in boot mode, and you are trying to perform a software recovery on your Switch.
As you mentioned there are lights on PWR and SYST, If there is an amber/orange light on the "SYST" and a green light on the "PWR" on the Switch (as it is in the below picture). Meaning the Switch is stuck in the boot mode.
Basically, due to the power outage/ power spike, the switch went to a state that we call ‘boot mode’ that is not able to boot up properly.
Please follow the below steps to fix this issue:
First, we will try to reset the Switch as described below:
1. Please try to disconnect from the Power outlet the ICX-7150 and reconnect.
2. Please try to press the reset button using a paper click or a small stick
Remove power from the switch.
Press and hold the Reset button while applying power to the switch.
After all the system LEDs flash amber, release the Reset button.
Below is the Guide and Videos link for your reference: