cancel
Showing results for 
Search instead for 
Did you mean: 

Re: R510 Not powering on

NickM0511
New Contributor

Good Evening -

I am continuing to have multiple issues with all of my Ruckus equipment in my Lennar home. 

My ICX 7150 switch that came with my Lennar Home is stuck in boot mode after a power outage. I have tried to reboot by doing the factory reset around 15-20 times and it stays stuck with all of the lights flashing amber. I have an iMac computer and have followed the instructions for a reinstalling the drivers and software. When connected to the computer via USB to C cord and ethernet cable it does not even detect my ruckus switch.

At this point, I believe the ICX 7150 switch and the R510 access point are RMA.

Please advise on what else I can do to resolve the issue.

14 REPLIES 14

Imran_ruckus
Moderator
Moderator

admin test

Imran_ruckus
Moderator
Moderator

Hi @NickM0511

Greetings!!!

Thank you for contacting RUCKUS Lennar Home Community.

I hope you are doing well!!!

Thank you for the information you shared.

As per the case description, I understand that your RUCKUS ICX-7150-C12P Switch is stuck in boot mode.

Could you please let me know the current status of the lights on the Switch? On your switch while it's plugged into the outlet, do you see any lights on? (Amber or green) Please let us know which lights are on. (Please refer to the below picture and share a picture of the same, showing the light status and the FULL Switch panel cable connections to the Switch ports)

Imran_ruckus_0-1712234267953.pngPlease help me with the above query and let me know if you have any queries in this regard.

Thank you again for your patience and understanding.

 

Best regards,

Imran Sanadi

RUCKUS Lennar Home Community.

Imran_ruckus
Moderator
Moderator

admin test

Hello -

Last evening I plugged my MAC into the switch to attempt the software recovery process again, and without doing anything, the SYST light turned a solid green.

The switch seems to be performing normally as of right now and one of my AP's is getting power and operating normally.

My second R510 AP still is not receiving power, via POE connection.

I have attempted to plug it directly into the switch with another ethernet cable, but there is no power being provided.