R150 AP stuck in boot mode

[InlineSix24]

POE Ethernet port light is green. PWR light on the front panel stays red after power cycling. Unleashed app shows the AP as offline. I have unplugged the POE and plugged it back in with no change. I have also tried holding the reset button for 45 seconds using a paper clip - PWR light continued to persist as red. I removed the AP and tried a different direct POE Ethernet cable with no success.

[Imran_ruckus]

Hi @InlineSix24 

Greetings!!!

Thank you for reaching out to the RUCKUS Lennar Home Community. 

We appreciate your patience and understanding as we work to resolve the issues you are experiencing with your RUCKUS setup.

Based on the information provided, it appears that you are encountering an issue with the RUCKUS Access Point with Red PWR LED.

We apologize for any inconvenience this has caused and are committed to assisting you promptly.

Could you please try connecting the affected Access Point to an external power 12 VDC adapter and check it separately without connecting to the Switch PoE port cable? (Please refer to the below screenshot). Usually, you will find the 12 VDC adapter connected to your ISP’s (Internet Service Provider’s) Router/Modem-Router combo device.

Once you connect to an external power adapter, please try to factory reset as described in the below guide.

Physical Factory Reset of RUCKUS Access Point:

https://community.ruckuswireless.com/t5/RUCKUS-Support-for-Lennar-Homes/Physical-Factory-Reset-an-Ac...

Please check the Access Point following the above process and let me know if it works.

Thank you again for your patience and understanding.

Best regards,

Imran Sanadi

RUCKUS Lennar Home Community.

[InlineSix24]

Thanks Imran-

Powering and resetting the AP with the power adapter does not cause a successful reboot and the solid red LED is persistent.

[Imran_ruckus]

Hello @InlineSix24 

Greetings!!!

Thank you for your response and the information provided on the private chat.

We kindly request that you connect this affected RUCKUS R510 Access Point (AP) to a functional power outlet and share both pictures and a single video showcasing the light status, the cord connected to the APs, and its connection to a working power outlet. Please refer to the example pictures provided below for guidance.

For the video upload, we have created a designated link for your convenience. You can access it via the following link: (Refer to the EXAMPLE VIDEOS from this drive link)

Kindly shoot a video similar to the EXAMPLE Video provided in the link. 

In the video, please ensure to capture the following:

1. Show the plug of the ICX-7150-C12P Switch being connected to a working outlet.

2. Simultaneously, display the light status on the switch.

https://drive.google.com/drive/folders/16lG-j0MSKzjqBJSY4rsgh4myUlseA9bz?usp=sharing

If you have any questions or need further clarification, please don't hesitate to reach out.

Thank you once again for your patience and cooperation.

Best regards,
Imran Sanadi
RUCKUS Lennar Home Community.

[InlineSix24]

I have uploaded the images and video now to a subfolder. The affected unit is the secondary AP. I have also included the current unleased status showing the functioning master AP.