Icx 7150-c12p syst orange

[faddymak]

Performed reset but all lights still flashing Amber!!

[faddymak · Accepted solution]

Found it 

its resetting, will I have to still create the wifi name and password or will it use the one ones that were there before the issue ?

[faddymak]

There are 3 files in the upgrade steps though 

[Imran_ruckus]

Hi @faddymak 

Thank you for the response.

As mentioned previously, please ignore those 3 files from the link. Only use the file I shared you in the drive link in place of 8095h. Only use SPS08095gufi.bin

Once you configure TFTP server, please follow the below commands as mentioned in the guide as well:

“copy tftp flash <tftp ip address> SPS08095gufi.bin primary”             -    (upgrade the image)

“Show flash”                                                             -  (check the primary flash has the new code)

“Write memory”                                                                                                     -  (save the changes)

“boot system flash primary”                                            -   (boot the Switch with the new code)

After the Switch comes back, run the next final command to copy what is in the primary partition to the secondary because we need that both partitions match.

"copy flash flash secondary"   - (will copy what is in the primary)

Please let me know if you have any queries in this regard.

Thank you again for your patience.

Best regards,

Imran Sanadi

RUCKUS Lennar Home Community.

[faddymak]

 Is that all I need in the folder ? 

[faddymak]

 

[Imran_ruckus]

Hi @faddymak 

Thank you for the response and the update.

Please try to use different IP address from the Server interfaces.

Please check and let me know if you have any queries in this regard.

Thank you again for your patience.

Best regards,

Imran Sanadi

RUCKUS Lennar Home Community.