ICX-7150 Switch issue

[sjpolen]

I have an issue stemming from a recent power outage. My primary image is corrupt, and the secondary image is the SPRxxxxxx.bin image which does not work in my configuration. I downloaded the latest stable image from the website which was listed as SPS08095g, but when I tftp'd it up I got an error stating "Invalid FI Image File: Header Type 0x403. I also received "Error: The header crc a000000 and the calculated crc 4c05e3bd mismatch" after the TFTP transfer was complete. I figured I would download it all again and check my configuration, but I got the same results. What am I doing wrong? 

[Vásquez_Fer]

Hi @sjpolen 

Could you please sent us the following commands ( entire ) 

Enable

Show version

Show flash 

I will leave some upgrade guides using a USB flash driver or TFTP / GUI 

How to Upgrade a Switch ICX-7150-C12P using a USB flash drive

https://community.ruckuswireless.com/t5/RUCKUS-Support-for-Lennar-Homes/How-to-Upgrade-a-Switch-ICX-...

How to perform an Upgrade via Web GUI (ICX7150 Switch)

https://community.ruckuswireless.com/t5/RUCKUS-Support-for-Lennar-Homes/How-to-perform-an-Upgrade-vi...

How to upgrade a Switch ICX7150-C12P via TFTP

https://community.ruckuswireless.com/t5/RUCKUS-Support-for-Lennar-Homes/How-to-Upgrade-a-Switch-ICX-...

Best Regards 

Fernando Vasquez 

[Vásquez_Fer]

Hi @sjpolen 

I got your outputs  here : 

Since you are running SPR08080d you need to follow up the upgrade path that is 8080f then 8095g you can not jump directly from 8080d to 8095g.

if you want to solve the know issue with routing code you can execute or run these commands:

enable
copy flash flash secondary 
boot system flash secondary 

Once the unit boot up it should SPS

Note: Some times you need to run the copy flash flash secondary multiple times if you get an error.

If that doesn't work I left the guides in my first post on how to do the upgrade correctly using usb/tftp/GUI

Best Regards

Fernando Vasquez

[sjpolen]

Mr. Vasquez, 

I wanted to provide an update for my resolution. I was not able to run the IOS commands you mention above. For some unknown reason, the GUI method wouldn't work for me as I had issues with the username/password. After some digging, I found another post here https://community.ruckuswireless.com/t5/RUCKUS-Support-for-Lennar-Homes/How-to-Upgrade-a-Switch-ICX-... and followed it. I was able to load the mnz10114.bin with the image named SPS08080f.bin. I had to modify the commands listed in the procedure based on the being in the bootloader mode. I did not have success loaded the 08095gufi or 08095hufi image and still recieved the CRC errors. Any thoughts on why that may be the case?

[Vásquez_Fer]

Hi @sjpolen 

Did you reboot the unit to start running 8080f ? 

Please sent me the commands 

Show version 

Show flash 

Best Regards 

Fernando Vasquez