Showing results for 
Search instead for 
Did you mean: 

ICX 7150 Switch Reboots Every ~30 minutes

New Contributor

Starting from last night my Ruckus switch ICX 7150 keeps rebooting every ~30 minutes, causing all Ruckus access to reboot as well since they loose power over ethernet. There was no configuration changes it started out of blue and I can see other users in this forum complaining about the same. I have tried to disconnect the power for some time and reconnect it back, this doesn't help, the switch keeps rebooting.

Switch version:
No password has been assigned yet...
telnet@ICX7150-C12-Switch#show version
  Copyright (c) 2017 Ruckus Wireless, Inc. All rights reserved.
    UNIT 1: compiled on Nov 20 2018 at 00:09:55 labeled as SPS08080d
      (25968884 bytes) from Primary SPS08080d.bin
        SW: Version 08.0.80dT211
      Compressed Boot-Monitor Image size = 786944, Version:10.1.14T225 (mnz10114)
       Compiled on Thu Nov 15 12:59:22 2018

HW: Stackable ICX7150-C12-POE
UNIT 1: SL 1: ICX7150-C12-2X1G POE 12-port Management Module
      Serial  #:FEK3813R071
      Software Package: BASE_SOFT_PACKAGE   
      Current License: 2X1G 
      P-ASIC  0: type B160, rev 11  Chip BCM56160_B0
UNIT 1: SL 2: ICX7150-2X1GC 2-port 2G Module
UNIT 1: SL 3: ICX7150-2X10GF 2-port 20G Module
1000 MHz ARM processor ARMv7 88 MHz bus
8192 KB boot flash memory
2048 MB code flash memory
1024 MB DRAM
STACKID 1  system uptime is 6 minute(s) 2 second(s)               
The system started at 01:25:34 GMT+00 Sat Jan 01 2000

The system : started=warm start   reloaded=by "reload"

telnet@ICX7150-C12-Switch#show flash
Stack unit 1:
  NAND Type: Micron NAND 2GiB (x 1)
  Compressed Pri Code size = 25968884, Version:08.0.80dT211 (SPS08080d.bin)
  Compressed Sec Code size = 29819448, Version:08.0.80dT213 (SPR08080d.bin)
  Compressed Boot-Monitor Image size = 786944, Version:10.1.14T225
  Code Flash Free Space = 1249460224

Please advise.



Hi @Pavel 


Thank you for contacting RUCKUS Lennar Home Community.

I hope you are doing well!!!

Thank you for the information you shared.

As per the case description, I understand that your RUCKUS setup is not working, with RUCKUS Switch rebooting frequently.

I see your RUCKUS Switch is on an older 8080d version may causing this issue. We suggest you upgrading the Switch to the latest stable version.

The recommended stable version is 8095g (08.0.95g)

The Upgrade path would be: 08080d (your current version)>>8080f>>8095g

(PLEASE NOTE: Use 08095g patch in place of 8095h as explained in the guide, IGNORE 8095h)

Your Upgrade folder should contain these 3 files shown in the below screenshot: (Refer the guide link for more information)

Below are the options or methods to perform the Upgrade on the switch: You could choose any one of these.

1st Option:

1. In this option, we will use a pen drive or USB flash drive in which we move the files to the pen drive and connect it to the Switch then through CLI we execute the commands to upgrade the Switch using the following guide as a reference:

How to Upgrade a Switch ICX-7150-C12P using a USB flash drive

2nd Option:

2. The following guide is an example of an upgrade via TFTP server, by using an application (FREE) to send files or upload remote files to a device, in our case, we will use it to update a new version to the Switch, basically it will send the image version remotely from the computer to the switch.

How to upgrade a Switch ICX7150-C12P via TFTP

3rd Option:

3. In this option we Upgrade the Switch from the Web Interface (GUI) of switch.

Try to access your switch from a web browser by pasting the below URL in http or https form whichever that works. or (IP address of Switch. is just as an example)

As you can access CLI, I would suggest you follow the 2nd option.

Please let me know if you have any queries in this regard.

Thank you again for your patience.


Best regards,

Imran Sanadi

RUCKUS Lennar Home Community.


Hi @Pavel 

Please follow the Upgrade process as described in my previous post and let me know if you need any assistance at any point.

Thank you again for your patience.


Best regards,

Imran Sanadi

RUCKUS Lennar Home Community.