cancel
Showing results for 
Search instead for 
Did you mean: 

ICX 7150 C12P Admin login incorrect and can't console

laurentaylor089
New Contributor

OUR RUCKUS HASNT BEEN WORKING FOR 4 MONTHS NOW:

We recently had a power outage and our wifi stopped working well. In the unleashed portal i saw our switch was noted as disconnected. On the physical switch the SYST and PWR Lights  are green and everything appears to be fine same with all of our APs. Research in this portal led me to this post https://community.ruckuswireless.com/t5/RUCKUS-Support-for-Lennar-Homes/Unstable-Lennar-Ruckus-Servi... and I also tried to access via inputing the IP address of switch in browser and login, but non of the various combinations of passwords from the forum worked. When going through the steps in the linked post this was the command line issues i received. 

"

Last login: Sat Jan 13 17:14:07 on console

laurentaylor@Laurens-Air ~ % nc 192.168.1.164 23

laurentaylor@Laurens-Air ~ % ssh admin@192.168.1.164

Unable to negotiate with 192.168.1.164 port 22: no matching key exchange method found. Their offer: diffie-hellman-group14-sha1,diffie-hellman-group1-sha1

laurentaylor@Laurens-Air ~ % ssh super@192.168.1.164

Unable to negotiate with 192.168.1.164 port 22: no matching key exchange method found. Their offer: diffie-hellman-group14-sha1,diffie-hellman-group1-sha1

laurentaylor@Laurens-Air ~ % 

"IMG_2057.jpgScreen Shot 2024-01-13 at 4.42.24 PM (2).pngIMG_1452.jpg

6 REPLIES 6

Hi @laurentaylor089 

Greetings!!!

Thank you for the response and the update.

Please follow to the below screenshot and enable Telnet:

Once you enable Telnet try to access CLI from the MAC terminal as described below. And share the output of the commands mentioned below in this post.

If you have a MAC device, please try the below process. 

Example "open terminal":

Telnet: Example

nc 10.0.0.132 23 (Format is : nc <ip address of the switch> 23)

Please enter the below commands once you log in to CLI and share the output.

Note: Hit Enter to accept each command 

enable

show version

show flash

Please share the output of the above commands or share the screenshots if stuck at any step or error (if any) and let me know if you have any queries in this regard.

Thank you again for your patience and understanding.

 

Best regards,

Imran Sanadi

RUCKUS Lennar Home Community.

Hi @laurentaylor089 

Greetings!!!

I am writing to request an update on the status of the issue. Your prompt response would be greatly appreciated as we need to proceed further.

Thank you.

 

Best regards,

Imran Sanadi

RUCKUS Lennar Home Community