01-18-2025 05:26 AM
Hello, all lights on my Ruckus ICX 7150 are blinking after performing the following steps over 20 times:
1-Please try to disconnect from the Power outlet the ICX- 7150 and reconnect it.
2-Please try to press the reset button using a paper click or a small stick
02-03-2025 05:39 AM
Hello @deeguyon ,
Thank you for the response.
I understand that you are getting stuck while performing the software recovery.
I would request you to please share the cable connection between the Switch and the laptop while performing software recovery. (Please see the below picture as reference)
COM port details should be with the silicon lab name in the device manager.
I would request you to please check if both the drivers are installed as per the software recovery article.
Once again, please make sure to download the zip drive for the file below & "extract all". Once it's extracted, run the file, the driver should be installed using the 2 links below.
Link 1: https://support.ruckuswireless.com/software/1414-brocade-ruckus-7150-usb-serial-driver-windows
Link 2: silabs.com/developers/usb-to-uart-bridge-vcp-drivers?tab=downloads
Could you please restart the laptop after installing the drivers and check the COM port details in the Device Manger from the Control Panel?
Also, please wait for few minutes and check if boot> prompt is visible.
Please let us know if you have any queries in this regard.
Thank you for your patience and understanding.
Regards,
Pinky Rajendran
RUCKUS Lennar Home Community
02-06-2025 10:48 AM
Hello @deeguyon ,
Greetings!
This is a follow-up in reference to the case you have opened in the Ruckus Lennar Support Community.
I would like to know if you require further assistance since our last correspondence. Should you have any questions or if the status of your case has changed, please let me know by responding to this post.
Please feel free to contact if you have any further concerns regarding the same.
Best regards,
Pinky Rajendran
RUCKUS Lennar Home Community.
02-07-2025 05:51 AM
Hello @deeguyon ,
Greetings!
This is a follow-up in reference to the case you have opened in the Ruckus Lennar Support Community.
I would like to know if you require further assistance since our last correspondence. Should you have any questions or if the status of your case has changed, please let me know by responding to this post.
Please feel free to contact if you have any further concerns regarding the same.
Best regards,
Pinky Rajendran
RUCKUS Lennar Home Community.
02-10-2025 06:36 AM
Hi @deeguyon ,
Greetings!
I trust this message finds you well.
I kindly request an update on the status of the issue so that we may proceed further with resolving it.
If we do not receive a response from you within 24 hours from the timestamp of this message, your case will proceed to closure.
Thank you.
Best regards,
Pinky Rajendran
RUCKUS Lennar Home Community