cancel
Showing results for 
Search instead for 
Did you mean: 

After ICX 7150 c12p factory reset need help assigning Ip address and basically setting everything

mpyrtle
New Contributor III

I had to repost because it wasn’t in the Lennar forums I was told. Yes this is for a Lennar smart home.

Hello. I had to reset my ICX switch to factory and now I need a walk through to set everything back up.

I am able to get to the switch via the command line with USB-C to from the switch to my laptop. I was able to create a new password after the reset but I really don’t understand or know the commands like that to assign the IP address, default gateway, and TFtp. I have download putty and TFTP but as of now I’m stuck on assigning a IP address to the TFTP on the switch. 

The commands I found on the forums seems to not work when trying to assign IP address. I just need a up to date or someone to speak to help assist getting the switch not the AP back functioning from the Lennar setup please..

1 ACCEPTED SOLUTION

mpyrtle
New Contributor III

@imran_ruckus @sgatjens

Same issue. I change the IP address to match the IP within CLI.

mpyrtle_2-1708977941869.png

 

mpyrtle_0-1708977836141.png

mpyrtle_1-1708977907152.png

mpyrtle_3-1708977977406.pngmpyrtle_4-1708978022105.png

 

 

 

 

View solution in original post

18 REPLIES 18

mpyrtle
New Contributor III

@imran_ruckus @sgatjens

mpyrtle_0-1708664975183.png

 

Hi @mpyrtle 

Greetings!!!

Thank you for the response and the update.

Yes, that is the expected error since the software recovered version is non-UFI. And we cannot software recover on the UFI version.

It should not affect the normal working of the Switch after software recovery.

However, you can upgrade your Switch to the recommended UFI version by following the below RUCKUS Knowledge base self-help guide.

https://community.ruckuswireless.com/t5/RUCKUS-Lennar-Support-Knowledge/How-to-upgrade-RUCKUS-ICX-71...

Please let me know if you have any queries in this regard.

Thank you again for your patience and understanding.

 

Best regards,

Imran Sanadi

RUCKUS Lennar Home Community.

mpyrtle
New Contributor III

@imran_ruckus @sgatjens

So I want to do the article you suggested, but I'm having issue with the switch getting a IP. In the CLI I did a show ip command and got this:

Switch IP address: 192.168.0.3  255.255.255.0.

I'm able to ping it but ISP is different and other devices starts off with 192.168.4.x.

It seems the switch is not allowing the ISP assign a default IP within my domain. I also steal cannot log into the switch via the GUI because the passwords that were mention for username (admin) or (super) didn't work. That was orignally the whole point on doing a factory reset on the switch. Any suggestions that I can do in regards to the IP assigning to the switch or getting off the default IP that switch is assign to that not on my domain.

 

 

 

Hi @mpyrtle 

Thank you for the response and the update.

If you are unable to locate the IP Address, please continue the upgrade using console CLI as you already able to access it.

Please let me know if you have any queries in this regard.

Thank you again for your patience and understanding.

 

Best regards,

Imran Sanadi

RUCKUS Lennar Home Community.

mpyrtle
New Contributor III

mpyrtle_0-1708720529299.png

Getting this error when trying to do the upgrade.