510 in reboot cycle after power outage

[Jbails7]

510 in reboot cycle after power outage.

1. PWR will blink and eventually turn solid green

2. CTR will slow blink, then switch to a rapid blink

3. PWR will then turn solid red.

Everything was working fine until the power went out for 8 hours.  Any recommendations?  I'm a noob with this stuff and don't know how to access settings from desktop. 

[Vineet_nejwala]

Yes F/D is factory reset. Since this is a multi AP setup you can perform the same on the impacted AP , FYR below link. Once the AP has completed the f/d and boot process it should initiate auto discovery and connect to the other two AP on same network. This should stabilize the AP.

https://support.ruckuswireless.com/articles/000010931

Best Regards

vineet

[Jbails7]

Once I push the F/D button for 10-12 seconds do I actually need to do anything else or should the device just auto boot/reconnect?

Also, the instructions mentioned something about unplugging my other 2 working AP's before performing the F/D on the bad AP.  Is this correct?  Just want to make sure I don't make the situation worse. 

Thanks for your help 

[Vineet_nejwala]

You need to press the f/d button for 15-20 seconds and no need to remove other two working AP model from the network.

Best Regards

Vineet

[Jbails7]

Unfortunately, this did not solve the problem. 

[Koby]

How did you overcome the issues. I have the same thing with R550