510 in reboot cycle after power outage

[Jbails7]

510 in reboot cycle after power outage.

1. PWR will blink and eventually turn solid green

2. CTR will slow blink, then switch to a rapid blink

3. PWR will then turn solid red.

Everything was working fine until the power went out for 8 hours.  Any recommendations?  I'm a noob with this stuff and don't know how to access settings from desktop. 

[Squozen]

What controller are you using?

[Jbails7]

We have three R510 hooked up to a ICX 7150 - C12P.  One of the R510 no longer works after the power went out for 8-10 hours.  We live in a Lennar new build home.  I'm a complete noobie at this stuff.  Any help would be greatly appreciated. 

[Vineet_nejwala]

Hi @Jbails7 

A power off shouldn't impact the AP performance, if that was the only impact it had.  If this is an individual AP and is in indefinite loop even after powering off for sometime and considering this is an Unleash model you can try performing a F/D on this AP. This should stable the AP but you would need to configure it again.

https://support.ruckuswireless.com/articles/000010931

Best Regards

Vineet

[Jbails7]

We have three R510 hooked up to a ICX 7150 - C12P.  One of the R510 no longer works after the power went out for 8-10 hours.  We live in a Lennar new build home.  

Is F/D mean factory reset?